A ground stop is an FAA order that keeps flights headed to a particular airport (or through a particular piece of airspace) on the ground at their departure airports until the order is lifted. A ground delay program is the gentler version: flights still go, but each one gets an assigned departure time, an EDCT, so that arrivals reach the constrained airport at a rate it can handle. Both are decided by the FAA's Air Traffic Control System Command Center, not by your airline, and both explain most "delayed at the gate, sky perfectly blue" afternoons.
Below: how the two differ, what EDCTs and airspace flow programs are, how to read the FAA's NAS Status page, how long these programs last, and what they look like in flight status data.
What is a ground stop?
The FAA's facility order for traffic management, JO 7210.3, section 18-13, defines a ground stop as a process that requires aircraft meeting specific criteria to stay on the ground. The criteria can be an airport ("all departures to San Francisco"), a piece of airspace, or a type of equipment. The ones passengers meet are almost always airport ground stops: every flight bound for, say, Newark is held wherever it is.
The order lists the uses: severely reduced capacity (weather below arrival minimums, a runway closed for snow removal, an accident), preventing long airborne holding or gridlock, an ATC facility that cannot provide full service, and routes closed by severe weather.
Three properties matter for travelers:
- They come with little or no warning. The order says so in as many words.
- They override everything else. A ground stop beats every other traffic management initiative, including a ground delay program already running. A flight holding an EDCT does not leave while a ground stop covering it is in effect, unless whoever issued the stop approves it.
- They are a last resort. Before a national ground stop, the FAA must evaluate less restrictive measures first.
There are two flavors. A local ground stop is issued by a single facility when everything affected sits inside its own area and conditions are not expected to last more than 30 minutes. A national ground stop is issued by the Command Center, which publishes an advisory naming the airport, the departure facilities included, an expected update time, the reason, and the probability of extension.
What is a ground delay program?
A ground delay program (GDP) solves a slower problem: the destination can still take arrivals, just fewer of them than are scheduled. JO 7210.3, section 18-10 describes it as holding aircraft on the ground "to manage capacity and demand at a specific location, by assigning arrival slots." The stated purpose is to limit airborne holding.
The Command Center sets an arrival rate for the airport, say 36 an hour instead of 60 because low clouds force wider spacing on approach. Every flight inbound to that airport from the included departure area gets an arrival slot. Subtract the flight's estimated time en route from its slot and you get its Expect Departure Clearance Time, or EDCT. The delay a flight receives is the gap between when it wanted to leave and its EDCT, and the program is designed to spread those delays equitably across airlines.
GDPs cover flights departing the contiguous United States and selected Canadian airports, not Alaska. Once a flight has an EDCT, the order says it should not be given additional delay, apart from approved spacing initiatives.
Ground stop vs ground delay program
| Ground stop | Ground delay program | |
|---|---|---|
| The problem | The destination (or route) can take almost nothing right now | The destination can take arrivals, but fewer than scheduled |
| What happens to your flight | Held at its departure airport until the stop is lifted or your flight is released | Assigned an EDCT; leaves at that time |
| Warning | Little or none | Usually some: the Command Center confers with facilities and airlines first |
| Departure time known? | No; the advisory gives a next update time | Yes, the EDCT, which can be revised |
| Typical trigger | Weather below arrival minimums, a closed runway, an ATC facility outage | An arrival rate cut by low clouds, wind or sheer volume |
| How it ends | Cancelled, sometimes replaced by a GDP | Revised, compressed, extended or cancelled |
One sequence is common enough to know: a ground stop goes in first to stop the bleeding, then a ground delay program replaces it once the Command Center has worked out a sustainable arrival rate. The FAA's NAS Status guide lists exactly this among the reasons for a ground stop.
What an EDCT means for your flight
An EDCT is a departure time with a narrow window. Under JO 7110.65, paragraph 4-3-4, the departure tower plans ground movement so flights depart no earlier than 5 minutes before and no later than 5 minutes after their EDCT. A flight that misses the window needs a new time from traffic management, and the new time is not guaranteed to be close to the old one. That is why a late passenger during a program can cost a flight far more than the minutes it took to board them.
The FAA runs a public EDCT lookup. It needs the call sign, origin and destination exactly as filed in the flight plan, which for an airline flight means the ICAO form: DAL1234, not DL1234 (the difference is explained in IATA vs ICAO codes). The page itself warns that EDCTs change with the program and recommends checking 45 minutes or less before departure.
Airspace flow programs
Sometimes the airport is fine and the problem is in between: a line of thunderstorms across the routes from the Northeast to the Southeast, for example. An airspace flow program (AFP) applies the GDP idea to a piece of sky. JO 7210.3, section 18-11 describes it as assigning arrival slots and corresponding EDCTs to manage demand through a flow constrained area. Flights planned through the area get an EDCT; flights that route around it may avoid one.
To a passenger an AFP looks exactly like a GDP, with good weather at both ends of the trip. NAS Status lists AFPs under en route events, not airport events, so checking only your destination can miss them.
How to read the FAA NAS Status page
The FAA publishes all of this live at nasstatus.faa.gov; the old fly.faa.gov address forwards there. Per the FAA's NAS Status user guide, it updates every minute and has three main sections:
- Active Airport Events: airport closures, ground stops, ground delay programs, arrival and departure delays, and deicing, one card per airport.
- Active En Route Events: airspace flow programs, with the constrained area drawn on a map.
- Forecast Events: delays the Command Center expects later in the day, rated possible (under 30%), probable (30 to 60%) or expected.
| Event | What the card tells you |
|---|---|
| Ground stop | The reason, the time of the next update, the departure facilities included, and a probability of extension: low (under 30%), medium (30 to 60%) or high (above 60%). |
| Ground delay program | Average delay, reason, scope, the Command Center advisory, and a delay trend with the average delay for each hour. |
| Departure delay | Departing traffic faces longer than normal taxi times or holding at the gate. |
| Arrival delay | Arriving aircraft are being held in the air. |
| Deicing | The airport has a formal deicing program running. |
Arrival and departure delays are reported in 15-minute bands with a trend: "15 minutes and increasing" means more than 15 and under 30, and getting worse. Facilities must report delays of 15 minutes or more, so an airport with no card may still have shorter ones.
A worked example
Here is what the FAA's machine-readable feed listed at 03:16 UTC on November 10, 2026, which was the evening of November 9 on the West Coast:
| Airport | Event | Reason | Delay |
|---|---|---|---|
| LAS | Ground delay program | Other | Average 37 minutes, maximum 1 hour 20 |
| SEA | Ground delay program | Other | Average 1 hour 7, maximum 1 hour 52 |
| SAN | Ground delay program | Airport volume | Average 22 minutes, maximum 1 hour 23 |
| LGA | Departure delay | Wind | 31 to 45 minutes, increasing |
| SAN | Departure delay | Compacted demand | 16 to 30 minutes, increasing |
If you were booked into Seattle that evening from an airport inside the program's scope, a delay of around an hour at the gate was the program working as designed, whatever the weather where you were. Leaving LaGuardia, the problem was your own airport: a long taxi or a hold at the gate. And an average is an average: some Seattle flights were held close to two hours.
The page has a Local/Zulu switch. Advisories use UTC, so a ground stop "until 2200Z" in New York in November ends at 5 p.m. local.
Why your flight is delayed at the gate when the sky is clear
Because the constraint is somewhere else and the delay is deliberately taken on the ground. A GDP for Seattle assigns delay to flights all over the West so they arrive in a steady stream instead of all at once. The alternative is letting everyone leave on time and circle near Seattle, burning fuel and filling airspace; the FAA's order states that limiting airborne holding is the point.
With an AFP, the weather that matters may be hundreds of miles away over your route; with a ground stop, it is over a destination you cannot see.
If the airline has already boarded you, the wait may happen on the aircraft. For covered carriers, the DOT's tarmac delay rule requires an opportunity to deplane before a tarmac delay passes three hours on a domestic flight or four hours on an international one, food and water within two hours, and a status update after 30 minutes, with safety, security and ATC exceptions. For what you can claim afterwards, see delayed flight compensation in the US.
How long do ground stops and ground delay programs last?
The FAA publishes no "typical" duration, and a single number would mislead: a ground stop for a passing storm cell and one for a runway closure have little in common. The procedures do say this much:
- A local ground stop is only for conditions expected to last no more than 30 minutes, and cannot be extended without the Command Center's approval.
- A national ground stop advisory carries an expected update time and a probability of extension. The update time is the next decision point, not a promise that flights will move.
- A ground delay program advisory names the period it covers ("arrivals estimated for" a window of hours), the program rate, and the maximum or average delay. Programs are revised, compressed, extended and cancelled as conditions change.
The practical reading: during a ground stop, watch the next update time and the probability of extension on NAS Status; during a GDP, your EDCT and the program's delay trend are the best estimate available. When the Advisories Database shows a ground stop being replaced by a GDP, the uncertainty shrinks: flights get EDCTs, even if the delay is long.
How this shows up in flight status data
An airline status feed does not say "ground stop". There is no status code for it; what changes are the times.
In FlightByte, a flight held by a GDP stays in the scheduled phase with status.delayed: true, and its departure estimate moves as the airline updates it:
{
"status": { "code": "S", "label": "Scheduled", "phase": "scheduled", "delayed": true, "cancelled": false, "diverted": false, "departureGateDelayMinutes": 64 },
"departure": {
"airport": { "iata": "DEN", "timezone": "America/Denver" },
"times": {
"scheduledGate": { "utc": "2026-11-16T21:05:00.000Z", "local": "2026-11-16T14:05:00.000", "timezone": "MST" },
"estimatedGate": { "utc": "2026-11-16T22:09:00.000Z", "local": "2026-11-16T15:09:00.000", "timezone": "MST" }
},
"bestTimeUtc": "2026-11-16T22:09:00.000Z",
"delayMinutes": 64
}
}A subscription receives each move as a flight.updated event with a departure.estimated.changed change carrying from, to and deltaMinutes, and, once the gate delay moves by at least the subscription's delayThresholdMinutes, a delay.increased. The arrival estimate normally moves with it as arrival.estimated.changed. During a ground stop, expect several of these in a row as the airline pushes the estimate out in steps, until the flight finally moves and flight.departed arrives. The change types and the snapshot reference have the full lists, and scheduled, estimated and actual times explains which of those times to show.
If you notify people, set delayThresholdMinutes to something like 15: a GDP can nudge an estimate a few minutes at a time. If you want the "why", the FAA's NAS Status site serves the same airport list as XML at nasstatus.faa.gov/api/airport-status-information; joining it to a flight's origin and destination IATA codes is enough to tell a customer "Seattle is running a ground delay program" next to the new departure time. The delay notification guide shows the rest of that pipeline.
If you are building delay alerts, the quickstart walks you from an API key to a first signed delivery.
Checked against FAA sources (JO 7210.3, JO 7110.65 and the NAS Status user guide) and 14 CFR 259.4 on November 10, 2026.
Frequently asked questions
What does a ground stop mean for my flight?
Your flight cannot take off until the FAA lifts the ground stop or releases your flight, even if it is fully boarded. The problem is at your destination or on your route, not where you are. Check nasstatus.faa.gov for the next update time.
Is a ground delay program better or worse than a ground stop?
Usually better for the traveler, because a GDP gives every flight a specific departure time, the EDCT, and lets the system keep moving at a reduced rate. A ground stop holds flights with no departure time until it is lifted. A ground stop is often replaced by a GDP.
Can my flight leave before its EDCT?
Only slightly. The FAA's controller handbook has towers plan departures no earlier than 5 minutes before and no later than 5 minutes after the EDCT. An earlier time can only come from traffic management revising the EDCT, which does happen when programs are compressed.
Does a ground stop mean something dangerous happened?
Rarely. Most are about weather, volume, or a runway or equipment issue that temporarily cuts how many aircraft an airport can accept. Holding flights on the ground avoids having them circle in the air.
Where can I see current FAA ground stops and delays?
On the FAA's NAS Status page at nasstatus.faa.gov, which lists ground stops, ground delay programs, airport closures, arrival and departure delays and airspace flow programs, updated every minute. The FAA's EDCT lookup shows whether a specific flight has an assigned departure time.